Instruction of LED flexible light

  ■ Pay attention to the below when use ：
◎ When turning on the power, make sure the voltage is correspond to the requirement of different kinds Flexible Light.
◎ Don't lighten the wrapped Flexible Light in case of the emitting-heat couldn't go out, which would damage the LED & the light.
◎ Don't lighten the light when installing. Don't hammer the light with metal strip, hammer in case of destroying the LED inside.
◎ Before producing varies shape or curving to finalize the design, please pull out the light a little, light up for a while to heat and soft the light in order to install easily.
◎ Cut at the connected place only with ‘scissors' marked. No burrs in case of short circuit.

◎ The connection should be fastened well. Median connector and ending of the Light should be glued to prevent water when used outdoor.
◎ Work circumstance is -20 ℃ +60 ℃ . Keep well ventilated

  ■ Installation Instruction ：
◎Pull the LED flexible light out of the reel, connect the anode, cathode of the eliminator supply plug with copper wire of the light to lighten and heat the tube in order to install easily, be bent to produce shape, letters, etc.
◎ Concerning the round rope light, fix the bracket in a horizontal line at first, then line up the tube and put into the brackets.
◎Concerning the flat rope light, draw a horizontal line firstly, line up the light and place it on the line with face up, then fix the light with bracket and use screw to fasten light.
◎The current connects into the light should not surpass the power wire (controller).

  Features
Energy-conservation LED flexible light is a high level linear decorative light, which is produced with PVC plastic and many LEDS in series and in parallel.
◎ Durable, energy-conservation, long life time: 50000-100,000 hours.
◎ Florid, high-brightness, colorful and many standard colors are available.
◎ Soft, easy bend to shape many designs and letters, the effect will be better when work with the controller, producing chasing, rolling, scanning vivid effects. The bending time of 60 ～ 90° shouldn't exceed 5 times to avoid the break of the connected wires and LED bracket.
◎ Easy installation, can be used in the building and recreation places with the bracket, light channel, iron wire, iron net etc.
◎ Wide application, no need to connect with rectifiers, can work under -20 ℃ - +60 ℃ and adapt to the changing world temperature.